extron netpa u 1004

Extron NetPA U 1004

NetPA Ultra Series 1004

Audio system

Voltage gain

Line Outputs

Unbalanced output: -6 db;

Balanced output: 0 dB

Frequency response

Through DSP

20 Hz to 20 kHz, ±0.5 dB

Through amplifier

20 Hz to 20 kHz, ±1 dB

THD + Noise

Through DSP

<0.01% @ 1 kHz at maximum output level

Through amplifier

0.1% @ 1 kHz at 3 dB below clipping

S/N

Mic/Line In to Line Out

90 dB, 20 Hz to 20 kHz at maximum output (unweighted)

Mic/Line In to Speaker Out

90 dB, 20 Hz to 20 kHz at maximum output (unweighted)

Mic/Line In to Digital Out

90 dB, 20 Hz to 20 kHz at maximum output (unweighted)

Digital In to Line Out

100 dB, 20 Hz to 20 kHz at maximum output (unweighted)

Digital In to Speaker Out

100 dB, 20 Hz to 20 kHz at maximum output (unweighted)

Crosstalk

<-90 dB @ 1 kHz, fully loaded

Volume control

-100 dB to 0 dB (control 0 to 100 in 0.1 dB steps)

Audio input

Number/signal type

4 mono, mic/line, balanced/unbalanced

Connectors

(2) 3.5 mm captive screw connectors, 6 pole, mono, balanced/unbalanced

Impedance

>10k ohms unbalanced/balanced

Nominal level

-60 dBV, +4 dBu, -10 dBV adjustable via input gain

Maximum level

+21 dBu at rated THD+N when input gain is set to 0 dB

Equivalent input noise

<-120 dBV (1 µVrms) at 40 dB input gain

CMRR

>60 dB typical

Input gain adjustment

-18 dB to +60 dB in 0.1 dB steps, adjustable per input

Audio line output

Number/signal type

4 mono, line, balanced/unbalanced

Connectors

(2) 3.5 mm captive screw connector, 6 pole

Impedance

100 ohms balanced, 50 ohms unbalanced

Gain error

±0.1 dB channel to channel

Maximum level (Hi-Z)

>+21 dBu balanced;  +15 dBu unbalanced

Audio processing

D/A conversion

24 bit, 48 kHz

AT port — Audio Transport

Transmission type

Dante/AES-67, software selectable

Connectivity

1 RJ-45 connector, 1-port 100 Mbps to Dante interface

Inputs

4 channels Rx

Outputs

4 channel Tx

Audio format

24-bit uncompressed, selectable at 44.1, 48, 88.2, and 96 kHz sampling rate

Latency

Deterministic, based on user selection: 1.0 ms (default), 2.0 ms, 5.0 ms

Audio speaker output

Number/signal type

NetPA U 1004

4 channels, 4 or 8 ohms

NetPA U 1004-70V

4 channels, 70V

NetPA U 1004-100V

4 channels, 100 V

Connectors

(2) 5 mm screw lock captive screw connector, 4-pole

Load impedance

NetPA U 1004

4 ohms minimum

NetPA U 1004-70V

50 ohms minimum

NetPA U 1004-100V

100 ohms minimum

Amplifier type

Class D

Output power

NetPA U 1004

100 watts per channel, 4 or 8 ohms, 1 kHz, <0.1% THD

NetPA U 1004-70V

100 watts per channel, 70 V, 1 kHz, <0.1% THD

NetPA U 1004-100V

100 watts per channel, 100 V, 1 kHz, <0.1% THD

High pass filter

NetPA U 1004-70V/100V only

80 Hz, 12 dB per octave rolloff (On by default, Changeable via software)

Control/remote

Control port

(1) 3.5 mm captive screw connector, 5 pole

Serial

Serial host control port

1 bidirectional RS-232

Baud rate and protocol

38400 baud, 8 data bits, 1 stop bit, no parity

Pin configuration

Pin 1 = Tx, Pin 2 = Rx, Pin 3 = GND

Standby

Standby power control

Contact Closure

Pin configuration

Pin 4 = GND, Pin 5 = Standby

USB control port

1 rear panel female USB mini B

USB standards

USB 2.0, high speed

Ethernet host port

1 RJ-45 female connector

Ethernet data rate

10/100 Base-T

Program control

Configuration program for Windows® Extron Simple Instruction Set (SIS™)

General

Power supply

Internal. Input: 100-240 VAC, 50-60 Hz, 0.5 A

Power consumption and thermal dissipation

Temperature/humidity

Storage

-40 to +158 °F (-40 to +70 °C) / 10% to 90%, non-condensing

Operating

+32° to +122° F (0° to +50° C) / 10% to 90%, non-condensing

Cooling

Convection, no vents

Protection

Clip limiter, thermal, short circuit, DC output

Indication

Limiter/Protect LED indicates the onset of clip limiting, thermal cycling, or a short circuit.

Over Temp LED indicates when the amplifier exceeds the recommended operating temperature for optimal unit longevity.

Power LED indicates power state, DC output protection (see NetPA Ultra Series User Guide for details).

Mounting

Rack mount

Yes, with included brackets or optional 1U rack shelf

Enclosure type

Metal

Enclosure dimensions

1.7" H x 8.7" W x 10.5" D (1U high, half rack wide)

(43 mm H x 221 mm W x 267 mm D

Product weight

3.8 lbs (1.7 kg)

Vibration

ISTA 1A in carton (International Safe Transit Association)

Regulatory compliance

Safety

CE, c-UL, UL. Meets UL 60065, IEC 60065, and BSEN 60065 for AV equipment

EMI/EMC

CE, C-tick, EN 55103-1, EN 55103-2, FCC Class B, ICES, VCCI Class B

Environmental

Complies with the appropriate requirements of ENERGY STAR® (ENERGY STAR qualified amplifier), RoHS, WEEE.

Product warranty

3 years parts and labor

Everlast power supply warranty

3 years parts and labor

NOTE

0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu

NOTE

These connectors accept wires of 22 AWG to 12 AWG

NOTE

All nominal levels are at ±10%.

NOTE

Specifications are subject to change without notice.

KUNTA-AV%20LOGO-me.png

Yh­teys­tie­dot

KUNTA-AV


info@kunta-av.fi

kunta-av.fi


Ritalankatu 31

33400 Tampere

© Coaxial  OY 2020